konistehrad Posted October 2, 2008 Share Posted October 2, 2008 Hey all; apologies upfront if this is a repost. I've been banging my head against this sleep mode problem for a while now and I'm pretty close to throwing in the towel. I've got the typical problems with sleep mode: you put it into sleep mode, it goes to sleep fine. You attempt to wake it, however, it just sits there. What strikes me as curious, though, is the video BIOS tagline that shows while the system struggles to revive itself. I've heard other people talk about problems with the GMS950s and sleep mode; just curious to see if anyone else had conquered this beast. Thoughts? For the record, here's the system I'm using: Proc: Intel E1400 (2Ghz) Mem: 1GM 667Mhz MoBo: Abit i45-CV (945GC/ICH7 chipset) Install: iAtkos 4i updated to 10.5.5 Kernel: 9.5.0 Vanilla w/ superhai speedstep 950 Driver: 10.5.5 stock using this technique Thanks! edit: add kernel info :x Link to comment Share on other sites More sharing options...
Sergej Posted November 10, 2008 Share Posted November 10, 2008 Hi! I can't install my intel gma950, id 0x2772. I've installed ideneb 1.5.5 Could you tell me which driver you used? Thanks a lot! Sergej Link to comment Share on other sites More sharing options...
konistehrad Posted November 26, 2008 Author Share Posted November 26, 2008 I can't install my intel gma950, id 0x2772. I've installed ideneb 1.5.5Could you tell me which driver you used? Hey, sorry this is super late; I didn't see someone had replied to this post. I updated my sig with links to all of the drivers I'm using. Hope it helps! Link to comment Share on other sites More sharing options...
Sergej Posted December 2, 2008 Share Posted December 2, 2008 Hey, sorry this is super late; I didn't see someone had replied to this post. I updated my sig with links to all of the drivers I'm using. Hope it helps! Ok, but the link about driver for gma driver doesn't works!! Could you tell me how to install a working driver for gma 950 with id 0x02772? Thanks a lot... Sergej Link to comment Share on other sites More sharing options...
Anunnaki-777 Posted December 3, 2008 Share Posted December 3, 2008 Same device id here. I'm currently using a fresh msiwindosx installation and the GMA950 drivers for the nettop. Its hardware is a close match for my desktop which is the MSI Wind PC. It works as-is from a fresh installation but limited to 4:3 ratio and a single resolution. I am trying to get 16:9 and that may require editing some kext's and adding our device ID's. Link to comment Share on other sites More sharing options...
supermx3 Posted December 4, 2008 Share Posted December 4, 2008 mine has the same device id, i just ended up using the old frame buffer, works good just some small artifacing on some things, get full res change and stuff, make sure your mobo is set for S3 on sleep, mine wont sleep right unless its S3 Link to comment Share on other sites More sharing options...
konistehrad Posted December 4, 2008 Author Share Posted December 4, 2008 Er, perhaps I wasn't clear, sorry. A direct link to the driver pack for devid 0x2772 can be found here: http://forum.insanelymac.com/index.php?act...st&id=34478 It's the 3rd post in the link on my sig. Sorry if it was confusing. Also, I've more or less concluded that the problem exists in my shoddy discount motherboard. Thanks for the help tho, supermx3. Link to comment Share on other sites More sharing options...
Recommended Posts