MilesR Posted September 14, 2008 Share Posted September 14, 2008 Hi all Its been a while since I did anything regarding the OSx86 project...and I seem to have forgotten most of what I knew Back at the end of last year I was using iAtkos v1.0r2 to install OSX on my PC. Everything apart from the QE/CI worked from the install with no other changes. After playing around a bit with the kext's I managed to enable QE/CI - but I can not for the life of me remember exactly what I did to get it working. I bought a Macbook in February and after that I didn't see the point in using OSx86 on my main desktop PC since I'd be using the Macbook. However, recently I downloaded iAtkos version 4 (with 10.5.4) and figured I'd install that. Again everything installed fine apart from having QE/CI support. Now, looking at the kexts again I think I've identified the 2 that I changed previously (ATIRadeonX1000 & ATIRadeonX1000GA.plugin) - where I enter my device ID etc. in the strings. Then I remove the Extensions.mkext and reboot. However, whilst QE/CI then seems to be enabled, I get all right click etc. menus appearing in black (so that I can't see the options). Does anyone else have a similar issue? I did a search on the forums, but couldn't find anyone else reporting the same issue (could be me not searching the correct terms!). Thanks Miles Link to comment Share on other sites More sharing options...
MilesR Posted September 14, 2008 Author Share Posted September 14, 2008 Actually, I've now found a solution...thanks to another thread on here: http://forum.insanelymac.com/index.php?sho...rt=#entry837919 Link to comment Share on other sites More sharing options...
Recommended Posts