InsanelyMac Forum > Dual boot: Win+Mac, but Darwin don't want boot!

LaGuNa

Apr 30 2006, 06:29 PM

Well, I installed Tiger 10.4.1 from "tiger-x86.tar.bz2" on a partition of my hard disk. I set dual boot with "chain0" file.
Start up my PC, I can choise Win or Mac, but when I choise "Mac x86" Darwin load for few seconds and then my PC is reboot. Why??!? Help!!!

hack4ev3r

Apr 30 2006, 07:49 PM

QUOTE (LaGuNa @ Apr 30 2006, 08:29 PM)

Well, I installed Tiger 10.4.1 from "tiger-x86.tar.bz2" on a partition of my hard disk. I set dual boot with "chain0" file.
Start up my PC, I can choise Win or Mac, but when I choise "Mac x86" Darwin load for few seconds and then my PC is reboot. Why??!? Help!!!

Maybe your computer doesn't have SSE2?
thats the minimum for osx86

LaGuNa

May 1 2006, 12:39 PM

I checked with cpu-z and I've SS2. My notebook is a Toshiba A60, Intel P4 Mobile...

daGriech

May 1 2006, 02:25 PM

QUOTE (LaGuNa @ Apr 30 2006, 07:29 PM)

Well, I installed Tiger 10.4.1 from "tiger-x86.tar.bz2" on a partition of my hard disk. I set dual boot with "chain0" file.
Start up my PC, I can choise Win or Mac, but when I choise "Mac x86" Darwin load for few seconds and then my PC is reboot. Why??!? Help!!!

Darwin bootloader has some problems with extended partitions

choose "Mac x86" , press Enter and then quickly F8. select your mac partition and press Enter again.

gl&hf

LaGuNa

May 3 2006, 06:42 AM

Yeeeeeeeesssssssssssssssssssss!!! Tiger now works so fine!!!
Thanks soooooooo muuuuuuuuuch daGriech!!!

But, can I set the second partition as the default partition for Darwin at boot??!? It's so boring press F8 each time... :-P